Special thank you to : http://www.instructables.com/
The aim of this project is to maximize the flight time/ battery life of the very famous Hubsan X4 quad-copter. This will show how you build your own for very low cost, simple to build and fun to play with. The 3D print is 100% designed by me for use with spare parts from the Hubsan H107L model. It consists of a chassis that fit a receiver, four 7x20mm motors, four 3mm LED´s and a clip to hold the battery.
The weight of this chassis is only 4.18g plus battery clip 0.49g. The whole quadcopter including chassis, clip, LED's, motors, propellers and receiver is only 21g. Excluding battery, that is 25% lighter than the original H107L model which weight is 27.8g. Even loaded with a 380mAh battery it´s just 3.5g heavier than H107L without its battery.
With battery: 31.35g compared to commercial 38.15g.
Continuous flight time with a 380mAh battery was measured to 11.5 minutes. I don´t have a H107L to compare with but I think it´s maximum 10min. Please let me know it you have one!
The 2 gram circuit board is quite advanced for its small size. It has a built-in radio receiver, 4 Motor + 4 LED drivers (which also signals low battery level), 6-Axis Flight Control with automatic or remote gyro calibration, 4-Way Flip support, and both Beginners & Advance Mode for different range of performance. The radio transmitter can be calibrated as well with adjusted sensitivity, flight control fine tuning and remotely turn off LEDs. Fligh performance can
